User's Manual

Wi-Fi: 4 dBi
WCDMA/LTE
B2:
4.54 dBi
WCDMA B4 &
LTE B4/B66:
4.54 dBi
WCDMA/LTE
B5:
2.28 dBi
LTE B12: 1.8 dBi
LTE B13/B14: 1.8 dBi
LTE B71: 1.8 dBi
Antenna Type External PCB Antenna Internal PCB Antenna
Manufacturer Aristotle ublox
Antenna
Connector
Wi-Fi: R-SMA Male
WWAN: SMA Male
Wi-Fi: N/A
WWAN: N/A, External Only
Antenna Gain
Brand: Aristotle,
WiFi Model: RFA-25-JP266-79-250
LTE Model:RFA-LTE-JP187-79B300
Wi-Fi: 2 dBi
WWAN: N/A, External Only
Impedance(Ω) 50 Ohm 50 Ohm
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following: “Contains FCC ID:
2AARN-DLWPH-8M”. The grantee's FCC ID can be used only when all FCC compliance
requirements are met.
2.9 Information on test modes and additional testing requirements
This transmitter is tested in a standalone mobile RF exposure condition and any co-located or
simultaneous transmission with other transmitter(s) or portable use will require a separate class II
permissive change re-evaluation or new certification.
2.10 Additional testing, Part 15 Subpart B disclaimer
This transmitter module is tested as a subsystem and its certification does not cover the FCC Part
15 Subpart B (unintentional radiator) rule requirement applicable to the final host. The final host
will still need to be reassessed for compliance to this portion of rule requirements if applicable.
As long as all conditions above are met, further transmitter test will not be required. However, the
OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed.
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID can not be used on the final product. In these circumstances, the