Instructions / Assembly

Figure 4 Figure 5
Figure 3
max
Before lighting the re bowl
The fuel can is empty, it is recommended to ll bio-ethanol into the can on the initial use. After the fuel is used up, the fuel can can be
lled or refueled with bio-ethanol or gel fuel after it is cooled COMPLETELY.
Lighting the re bowl
Use a long match or extended butane lighter to ignite fuel. If the re bowl cannot ignite, repeat the step (See Figure 4).
Extinguishing the re bowl
Place the extinguishing cover onto glass shield until NO ames are present (See Figure 5).
OPERATION INSTRUCTIONS
4
NOTE: DO NOT exceed the "max" volume level while refueling the fuel can (see Figure 3).
NOTE:
(1). Each can burns approx. 1.5 hours.
(2). On the initial use, ames are short. Keep burning 5 minutes, ames will reach out to a desirable height.
(3). During the initial burn, you may smell a slight odor. The odor is temporary and will be absent on following burns.
(4). Do not use the short butane lighter to ignite the unit to prevent from the scalding.
(5). During the burning, the outer wall of re bowl and glass shield will become extremely HOT. DO NOT touch or move the
unit, DO NOT change the cans. Wait 30 minutes until it’s cooled COMPLETELY.
NOTE:
(1). DO NOT blow out the ames using mouth or electrical fan.
(2). DO NOT douse the ames using the water.
(3). After the burning, the outer wall of re bowl and glass shield is still extremely HOT. DO NOT touch or move the unit, DO
NOT change the cans. Wait 30 minute until it’s cooled COMPLETELY.
extinguishing cover
LIFE GETS BETTER WITH PHI VILLA