Instructions / Assembly

Care and Maintenance

Cleaning the Burner Assembly

– Make sure the grill is cool

1. Make sure all control knobs are in the OFF position,the LP gas supply valve has been closed, and

the gas hose is disconnected from the gas supply.

2. Detach burner by removing the cotter pins at the back of the burners to detach them from the brackets.

3. Detach ignition wire from electrode by hand only. DO NOT use pliers or any other tool as it may damage

the electrode or wire.

4. Lift burner slowly.

5. Ensure all burner ports are clear of clogs. Use of a pin or paper clip works well.

6. Ensure burner is free of any damage. If damage is found, replace it with new burner.

7. Ensure the end of the burner and primary air screen are clear from insect nests, dirt or debris.

Re-installing the Burner

Correct

Incorrect

Correct

Incorrect

Correct

Incorrect

WARNING:

If the instructions above are not followed, a ﬁre or explosion may result, possibly causing

serious bodily injury or death.

Other Care and Maintenance

1. Keeping outdoor cooking gas appliance is clear and free from combustible materials, gasoline and

other ﬂammable vapors and liquids.

2. Not obstructing the ﬂow of combustion and ventilation air.

3. Keeping the ventilation opening(s) of the cylinder enclosure free and clear from debris.

4. Visually checking burner ﬂames including pilot burner ﬂame if provided, with pictorial representations.

5. Clean outdoor cooking gas appliance, including special surfaces, with recommended cleaning agents, if

necessary.

6.Checking and cleaning burner/vent tubes for insects and insect nests. A clogged tube can lead to a ﬁre

beneath the grill.

7.Half-year maintenance once time.

ENJOY YOUR CAPTIVA DESIGNS

1. Be sure the gas valve oriﬁces are correctly positioned inside the burner inlet.

2. Reattach the screw/nut combination.