Instructions / Assembly

Care and Maintenance

Burner Assembly

Removing The Burner Assembly

1. Make sure all control knobs are in the OFF position, the LP gas supply valve has been closed, and

the gas hose is disconnected from the gas supply.

2. Open lid and remove cooking grate, ame tamers, clip for burner and burners.

3. Slide the burner forward and out of the rebox.

4. Detach ignition wire from electrode.

Cleaning the Burner Assembly

– Make sure the grill is cool

1. Make sure all control knobs are in the OFF position,the LP gas supply valve has been closed, and

the gas hose is disconnected from the gas supply.

2. Remove cooking grate and ame tamers.

3. Detach burner by removing the cotter pins at the back of the burners to detach them from the brackets.

4. Detach ignition wire from electrode by hand only. DO NOT use pliers or any other tool as it may damage

the electrode or wire.

5. Lift burner slowly.

6. Ensure all burner ports are clear of clogs. Use of a pin or paper clip works well.

7. Ensure burner is free of any damage. If damage is found, replace it with new burner.

8. Ensure the end of the burner and primary air screen are clear from insect nests, dirt or debris.

Re-installing the Burner

Correct

Incorrect

Correct

Incorrect

Correct

Incorrect

WARNING:

If the instructions above are not followed, a re or explosion may result, possibly causing

serious bodily injury or death.

Other Care and Maintenance

1. Keeping outdoor cooking gas appliance is clear and free from combustible materials, gasoline and

other ammable vapors and liquids.

2. Not obstructing the ow of combustion and ventilation air.

3. Keeping the ventilation opening(s) of the cylinder enclosure free and clear from debris.

4. Visually checking burner ames including pilot burner ame if provided, with pictorial representations.

5. Clean outdoor cooking gas appliance, including special surfaces, with recommended cleaning agents, if

necessary.

6.Checking and cleaning burner/vent tubes for insects and insect nests. A clogged tube can lead to a re

beneath the grill.

7.Half-year maintenance once time.

ENJOY YOUR CAPTIVA DESIGNS

1. Be sure the gas valve orices are correctly positioned inside the burner inlet.

2. Reattach the electrode and wire to the burner.

3. Reattach the screw/nut combination.