Reference Manual




Because the CCD element reflects light different than film, and
this cannot be communicated to the Contax.Using TTL flash
with the CONTAX 645 camera and the P+ back, will result in
a 2 f-stop overexposure. When using TTL flash, the exposure
compensation on the flash unit must therefore be set to –2 f
stops.
Cables shipping with P+ back for Contax 645 (Value added
Purchase only)
The P+ backs for Contax is shipping with the following cables
(Value added Purchase only):
Part# 50300143 Multi connector to Lens sync
(for use with Large format - in two shot mode)
Part# 50300144 From multi connector to mini
jack female (for use with Large format wakeup
cable or Kapture Group one shot adaptor
cable)
Part# 50300154 From multi connector to mini
jack on the Contax handgrip (used to enable
Host Capture from Computer)
