Reference Manual




When using the Phase One P+ back with a Hasselblad 555
ELD, the shutter release on the front of the Hasselblad must be in
the “DIG” position.
If, of any reason, you have to use the shutter
release in “Film” position (hardware defect on
the DIG button, etc.) You must make sure that the
Shutter latency is set to ”Short latency” in the P+
back or in the Capture One application.

On the Hasselblad 555 ELD the P+ back can be used with both
Long and short latency.
All other Hasselblad cameras requires you to set the P+ back to
Short latency.
By default your P+ back is set to Short latency, which means that
the P+ back will respond fast on triggering on the cost of battery
time.
To save battery time you can set the P+ back to Long latency,
and thereby gain extra valuable time before the battery is
drained. This on the cost of response time.
To learn how to setup latency please consult the Menu mode
section

A motor cable is not required when using the camera on an
Hasselblad 555 ELD body.
