Reference Manual



When one of the options is selected the
“Make Custom WB” will be blinking.
Now you are ready to capture the image
that should be used for white balancing.
Place the viewfinder center circle on an area
(gray card or neutral white surface) and
capture the image. You have now made the
custom white balance and it has been set as
the current capture white balance.
All subsequent captures will now have the
new custom white balance applied.
3 different custom white balances can be
defined and used as shooting white balances.

You can also choose to easily transfer a white balance from
Capture One to the P+ back:
Create a custom white balance inside Capture One.
While tethered to the computer select WB from the lower
right button on the P+ back.
Select “Custom1”, “Custom2” or “Custom3” on the P+
back depending on where you want to store the new white
balance.
Finally Click the “Set as capture white balance” button
inside capture One.
The P+ back will beep,
confirming that the custom
white balance is now
uploaded, will be applied
when the P+ back has been
disconnected.
1.
2.
3.
4.
