Reference Manual



For more information on capturing tethered with the Phase One
Capture One application please consult the online user guide
available in the Capture One Help menu.

The P+ back is designed to be used with the new medium format
cameras prepared for digital camera backs.The use on these
camera bodies can be done without any cables attached
between the P+ back and the camera body or lens. All timing
and communication is done in the electrical interface contacts in
the connecting plate.
Capturing images with the FlexAdaptor on large format camera
or a camera body without the digital interface is supported by
connecting the special lens sync cable that comes with the P+
back. For a guide to usage on a specific camera body, digital
or not please consult the corresponding chapters later in this
manual.

When the camera back is connected to the body, and a battery
is inserted or the IEEE1394/FireWire cable is connected.
The Camera back can be turned on by holding down the
"Power" button just below the P+ back display.

When the camera is powered up you will see a short blink in
the green and red LED's in the right hand side of the display and
you will hear a ready beep. The lights will turn off immediately.
This is an indication that the camera is ready to capture. In
general, if the LEDs are not illuminated the camera is ready.
