User Guide
89
Enabling Location Data in Capture Pilot
Location data is enabled inside the menu WiFi > Settings > Capture
Pilot > Capture Pilot Permissions
1. Set the “Geotag captures” to “On”, to let the IQ2 back geotag
captures when connected wirelessly with Capture Pilot.
2. Set the “Geotag CF card” to “On”, to let the IQ2 back geotag images
when connecting after a shot or on all cards inserted into the CF slot
Tagging les with location data via Capture Pilot
You do not need to be connected to Capture Pilot while you shoot. With
the “Geotag CF card” turned on as described above, Capture Pilot can
run in the background on your iPhone/iPad without being connected to
the IQ2 back.
To tag the les after the shoot, you then connect the IQ2 back, and all
the les on the CF-card are tagged with the corresponding coordinates
matched by the shooting time.
To get location data into your les after the shoot do the following.
1. Before Shooting - start Capture Pilot and click on the compass
needle in top right corner, so that it is enabled (orange).
2. Now you can just leave it running in the background until after the
shoot.
3. Once you connect your IQ2 back to Capture Pilot – the les on the
CF-card in the IQ2 back will be tagged.
4. If you have multiple cards that you have captured to, you can just
insert the cards one by one. Capture Pilot and the IQ2 back will tag the
les for you.
Conrmation that the les on the CF-Card are tagged
You will see this dialog on the IQ2 back when it is nished tagging the
les.