User Guide

3.11 Flash Compensation Settings

By combining a Metz ash and the SCA3952 adapter, the camera

adjusts for ash. It can be adjusted within ±3EV in increments of 1/3

steps.

1. Turn on the Power

Install the SCA3952 adapter on the Metz ash, and attach it to the

camera. Lock the ash in place using the locking knob on the ash

shoe. Turn the shutter release mode selector lever to the S or C position,

and turn ON the ash power switch.

2. When the ash charge conrmation lamp lights, press the set button

[A] . The icon is displayed on the main LCD panel.

3. Turn the front or rear dial to select the ash compensation value.

External LCD Panel (normal display)

4. When the shutter button is half-pressed, the display appears on

the external LCD, and appears on the LCD inside the viewnder with

a + compensation, or appears with a – compensation.

Viewnder LCD Readouts

- If the ash-charge mark is not displayed, the ash compensation

button [A] cannot be used.

- Keep pressing the set button to activate the ash compensation

mode. You can check the exposure compensation value.

- If you turn the shutter release mode selector lever to the L (power

OFF) position, the compensation value will be cancelled.

 



