User Guide

19
2.8 Attaching the IQ2 Back
The IQ back is fully integrated with the camera body and functions as a
part of the whole camera system.
Ensure that the Phase One 645DF+ camera mirror is up and the shutter
is open when no digital back is attached.
When attaching the IQ back to the camera body the shutter will close
and the mirror comes back down.
First remove the cover on the IQ back and 645DF+ camera. Next, slide
forward the lever [1] and push in button [2], and ensure that the bottom
part of the IQ back is placed correctly in the lower locking mechanism
on the back of the camera body before the upper locking mechanism is
pressed together. Failure to do this can cause an error with the camera
body where the shutter will continuously open and close. If this occurs,
remove the IQ back. Make sure the camera body is powered and press
button [2] while mounting the digital back.
Please be aware that the shutter should be in the correct starting
position (shutter open). If this is not the case, attach and remove the
IQ back again to make sure that the camera body gets in the correct
starting position.
Remove the IQ back by sliding forward the lever [1], pushing in button
[2], and by gently pulling away the top of the back rst. Be careful with
the contacts and protective glass on the back. Your IQ back should
always be protected by its plate when it is not attached to the camera.
NOTE:
When transporting the system, it
is important to make sure that the
mirror is locked up in the shipping
position.
To ship the system, rst detach the
digital back, and then remove the
battery from the camera body. Now
replace the digital back.
The mirror will stay locked-up in the
shipping position, until the battery
is re-attached.