User Guide
177
FCC Regulations:
§ 15.19 (a)(3)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device
may not cause harmful interference, and (2) this device must accept any interference received, including
interference thatmay cause undesired operation.
§ 15.21
Changes or modications not expressly approved by the party responsible for compliance could void the user‘s
authority
to operate the equipment.
§ 15.105 (b)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
§ 15.407 (e)
Operation on the 5.15-5.25 GHz frequency band is restricted to indoor use only. The FCC requires indoor use
for the
5.15-5.25 GHz band to reduce the potential for harmful interference to co-channel Mobile Satellite Systems.
§ 2.1093
RF Exposure Information (SAR)
This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency
(RF) energy
set by the Federal Communications Commission of the U.S. Government. The exposure standard for wireless
devices
employs a unit of measurement known as the Specic Absorption Rate (SAR). The SAR limit adopted by the
FCC is
1.6W/kg for an uncontrolled environment. Tests for SAR are conducted using standard operating positions
accepted by
the FCC with the device transmitting at its highest certied power level in all tested frequency bands. The FCC
has
granted an Equipment Authorization for this device with all reported SAR levels evaluated as in compliance
with the FCC
RF exposure guidelines.
Although the SAR is determined at the highest certied power level, the actual SAR level of the device while
operating
can be well below the maximum value. This is because the device is designed to operate at multiple power
levels so as
to use only the poser required to reach the network. In general, the closer you are to a wireless base station
antenna, the
lower the power output.