User Manual

Page 11 of 28
Document Reference Phalcon NT, Issue 9 and Date 07/04/2020
THIS IS THE PROPERTY OF PHAROS MARINE AUTOMATIC POWER LIMITED. DISCLOSURE OR REPRODUCTION IS FORBIDDEN
UNLESS AUTHORISED
Parts List
The following list identifies those parts that the end user will have interaction with, i.e. the external parts of the
RACON. Additionally the main assemblies inside the RACON are detailed, although it is not expected that the unit will
be disassembled at any time unless returned to the manufacturer, and disassembly should only be undertaken by
trained and approved technicians.
External Parts
SA00-701191 ANTENNA ASSEMBLY Qty 1
0000-793222 BASE HOUSING FOR LW26-701189 Qty 1
Main Internal Parts
SA00-701190 MAIN ELECTRONICS ASSEMBLY Qty 1
5C-0.75MM-LKSM-HF CABLE KIT Qty 1
CONN-19WAY-STRT-0001 19 WAY CIRCULAR CONNECTOR Qty 1
Software and Transponder Setup
The Transponder does not require the user to load any software. In normal operation the Transponder runs
autonomously with the necessary firmware already embedded in the unit.
In addition, the following software and PC hardware is required by the installer to be able to communicate and
change the settings that are under user control:
Configuration GUI (Software as supplied)
USB to Serial communications cable
Installation
The Transponder is supplied in custom packaging for safety during transportation. Should the unit need to be
relocated at any time it is recommended that it is carried in suitable packaging to avoid the potential for damage.
After the unit has been unpacked it should be inspected for any signs of damage that may have occurred during
shipping. Also included in the package is a USB to serial communication cable required to change the default settings
of the Transponder if required.