User Manual

Page 47 of 57
Document Reference Phalcon-NT11, Issue 2 and Date 24/10/18
THIS IS THE PROPERTY OF Pharos Marine Automatic Power. DISCLOSURE OR REPRODUCTION IS FORBIDDEN UNLESS AUTHORISED
Registered Address: 14 Castle Mews, Hampton, England, TW12 2NP οƒ— Company Reg. No. 06757705 οƒ— VAT Reg. No. GB222645483
0 = No Alarms
Any other value indicates an
alarm. Use the Alarms
Function to read back 1.1
1.11.5 Example
RLOG
SYSLOG SLEEP CYCLES : 0
SYSLOG WAKE UP CYCLES : 1
SYSLOG SLEEP AFTER CYCLE : 1
SYSLOG TOTAL CYCLES : 1
SYSLOG X BAND ATTEMPTS : 12
SYSLOG X BAND RESPONSES : 11
SYSLOG S BAND ATTEMPTS : 59
SYSLOG S BAND RESPONSES : 58
SYSLOG HOURS ALIVE : 0
SYSLOG ALARMS : 0x0
OK
ELMO>>
Figure 16 Example Output from the Run Time Log
1.12 Reset and re-start transponder β€œRST”
1.12.1 Description
Reset the transponder, this is a software reset. Calling the function will restart the system.
1.12.2 User Rights
Client Linwave Factory
User Rights
YES
YES
YES
1.12.3 Command and Parameters
Command RST
Parameter Title Type Min Max Description
P1 NONE