User Manual
Page 36 of 57
Document Reference Phalcon-NT11, Issue 2 and Date 24/10/18
THIS IS THE PROPERTY OF Pharos Marine Automatic Power. DISCLOSURE OR REPRODUCTION IS FORBIDDEN UNLESS AUTHORISED
Registered Address: 14 Castle Mews, Hampton, England, TW12 2NP Company Reg. No. 06757705 VAT Reg. No. GB222645483
1.5 Get Configuration “CFGGET”
1.5.1 Description
Returns the configuration settings of the transponder. Note that if the user is configuring the unit, for example
setting the Beacon ID, using “CFGGET” will display how the user has currently configured the unit. These value will
only persist if the user has saved “SAVE” the configuration. Verification that the values are stored can be achieved by
power cycling the unit or sending the Reset command “RST”.
The output from the “CFGGET” command depends on who is logged into the unit. For example if ‘Linwave’ are
logged in additional information is displayed compared to the client (end user).
1.5.2 User Rights
Client Linwave Factory
User Rights YES YES YES
1.5.3 Command and Parameters
Command CFGGET
Parameter Title Type Min Max Description
P1 NONE
1.5.4 Command Return
Command
CFGGET
Parameter Title Type Min Max Description
R1 See Examples
below