User Manual

Page 15 of 57
Document Reference Phalcon-NT11, Issue 2 and Date 24/10/18
THIS IS THE PROPERTY OF Pharos Marine Automatic Power. DISCLOSURE OR REPRODUCTION IS FORBIDDEN UNLESS AUTHORISED
Registered Address: 14 Castle Mews, Hampton, England, TW12 2NP Company Reg. No. 06757705 VAT Reg. No. GB222645483
Parts List
The following list identifies those parts that the end user will have interaction with, i.e. the external parts of the
RACON. Additionally the main assemblies inside the RACON are detailed, although it is not expected that the unit will
be disassembled at any time unless returned to the manufacturer, and disassembly should only be undertaken by
trained and approved technicians.
External Parts
SA00-701191 ANTENNA ASSEMBLY Qty 1
0000-793222 BASE HOUSING FOR Phalcon-NT Qty 1
Main Internal Parts
SA00-701190 MAIN ELECTRONICS ASSEMBLY Qty 1
Software and Transponder Setup
The Transponder does not require the user to load any software. In normal operation the Transponder runs
autonomously with the necessary firmware already embedded in the unit.
In addition the following software and hardware for a PC is required for the installer to be able to communicate and
change the settings that are under user control:
Docklight Terminal Emulator
USB to Serial communications cable
Installation
The Transponder is supplied in custom packaging for safety during transportation. Should the unit need to be
relocated at any time it is recommended that it is carried in a crate to avoid the potential for damage.
After the unit has been unpacked it should be inspected for any signs of damage that may have occurred during
shipping. Also included in the package is a communication cable required to change the default settings of the
Transponder if required.
The Transponder is secured to a platform using three or more bolts (suitable for M10 bolts torqued to a max of 15
Nm), arranged in the pattern given in Appendix A.