Instructions

Phaesun GmbH · Brühlweg 9 · 87700 Memmingen · Germany | Telefon +49
(
8331
)
990 42 0 · Telefax +49
(
8331
)
990 42 12 | info
@
phaesun.com · www.phaesun.com
present a safety hazard, modules should not be mounted such that the
front/top glass faces downward (e.g., on a tracking structure that po-
sitions the module with the junction box facing skyward during sleep
mode).
Clearance between the module frames and structure or ground is re-
quired to prevent wiring damage and allows air to circulate behind the
module.
When installed on a roof, the module shall be mounted over a fire- re-
sistant roof covering rated for the application.
The module is only guaranteed for use when its factory frame is fully
intact. Do not remove or alter the module frame. Creating additional
mounting holes may damage the module and reduce the strength of
the frame.
Modules may be mounted using the following methods only:
1) Frame Holes: Secure the module to the structure using the facto-
ry mounting holes. Stainless steel bolts, with nuts, washers, and lock
washers are recommended per module.
2) Pressure Clamps or Clips: Mount the module with the clips on the
side frame of the module. The side frames are attached to the lon-
ger sides of the module. Installers should ensure the clamps are of
sufficient strength to allow for the maximum design pressure of the
module. Clips and clamps are not provided by Phaesun.
3) End Mount: End mounting is the capture mounting of the length
of the module’s end frame to a supporting rail. The end frames are
on the shorter sides of the module. The end-mounting rail and clips
or clamps must be of sufficient strength to allow for maximum design
pressure of the module. Verify this capacity with the mounting system
vendor before installation.
6.0 Maintenance
Inspect all modules annually for safe electrical connections, sound
mechanical connection and freedom from corrosion. Periodically clean
the module surface with water and a soft cloth or sponge. Fingerprints
may be removed with standard glass cleaner. Do not use harsh clea-
ning materials such as scouring powder, steel wool, scrapers, blades or
other sharp instruments to clean the glass surface of the module. Use
of such materials will invalidate the product warrant.
7.0 Contact to Phaesun
For technical questions or information about the product, please do
not hesitate to contact us.
Phaesun GmbH · [e-mail] · [phone]