User manual

Phaesun GmbH · Brühlweg 9 · 87700 Memmingen · Germany · Telefon [phone] · [e-mail] · www.phaesun.com
3. LCD Display Instruction and Key Specification
LCD Display Instruction and Key SpecificationLCD Display Instruction and Key Specification
LCD Display Instruction and Key Specification
4.1 LCD Display Instruction
4.1 LCD Display Instruction4.1 LCD Display Instruction
4.1 LCD Display Instruction
1) Wind turbine symbol.
2) Day symbol. Night symbol.
3) Battery symbol，inner strip graph indicates the battery power status. Five inner horizontal strips display indicates the
battery is full. The symbol shall be flashing when the battery is over-discharge, flashing will not stop until battery
voltage recover. The symbol shall be flashing when the battery is over charge, flashing will not stop until battery
voltage recover.
4) Parameters display symbol. Each system parameters are displayed via visual digit and graph.
5) Press the "Enter" key and "Esc" button at the same time, LCD displays the symbol which indicates wind turbine
in brake status. Wind turbine will stop rotating or running in low speed under brake status. Press the "Enter" key and "Esc"
button at the same time under brake status, the symbol will disappear and brake status is released. In normal
situation, the wind turbine shall be in running status rather than brake status.
4.2 Button Specification
4.2 Button Specification4.2 Button Specification
4.2 Button Specification
LCD backlight will be on after pressing any button. The backlight will go out to save power if there is no button operation for
10 seconds.
 " ": Up/ Increase. In browsing status, press to check the previous parameter. In setting window, press this
button to check the next adjustable parameter or increase the value of current parameter.
 " ": Down/Decrease. In browsing window, press to check the next parameter. In setting window, press this
button to check the previous adjustable parameter or decrease the value of current parameter.
 "Enter": Set/Confirm. In browsing window, press "Enter" to access setting window. In setting window, press this button to
save parameters and return back to browsing window.
 "Esc": Cancel/Manual reset. In setting window, press "Esc" to return to browsing window without saving the modified
parameters.
4.3 Parameters Browsing
4.3 Parameters Browsing4.3 Parameters Browsing
4.3 Parameters Browsing
1） When power is on, the LCD is under browsing window and displays battery voltage: XX.X V;
2） In browsing window, LCD will circularly display the following parameters by pressing "
" button and " "