User manual

Step 4 Connect wind turbine output line to “WIND INPUT” terminals when the wind turbine is under static status or in low
speed running status. If the wind turbine is single-phase DC output, just connect the positive pole line to(+) “WIND
INPUT” terminal, negative pole line to (-)“WIND INPUT” terminal.
Step 5 Connect solar panel positive wire to (+) “SOLAR INPUT” terminal, negative wire to (-) “SOLAR INPUT” terminal.
Step 6 If the controller has the remote communication function, user can read and set relevant parameters via software.
Step 7 User can set relevant parameters and load output control modes through LCD buttons.
Step 8 Check whether all the connections are correct and firm.
4. LCD Display Instruction and Key Specification
4.
1. LCD Display Instruction
1)
Wind turbine symbol.
2)
Day symbol Night symbol.
3）
battery symbol，inner strip graph indicates the battery power status. Five inner horizontal strips display indicates the
battery is full. The symbol
shall be flashing when the battery is over-discharge, flashing will not stop until battery
voltage recover. The symbol
shall be flashing when the battery is over charge, flashing will not stop until battery
voltage recover.
4）
Load symbol, indicates the load status and malfunction status.

indicates load normal output indicates load without output
 The symbol
flashing indicates over-load, users must remove extra load, click “Esc” key to recover output.
Phaesun GmbH
·
Brühlweg 9 · 87700 Memmingen · Germany · Telefon [phone] · i
[e-mail] · www.phaesun.com