User's Manual

Getting Started
1. Unpack the paintball marker from the box
and inspect for any damage.
2. Install 9 volt battery. (See battery installa-
tion instructions on page 8)
3. Install barrel by screwing it clockwise into
the breech. (See figure 1)
4. Set the safety to safe position. (See figure 2)
5. Connect propellant source to the back of
the pressure regulator. (See figure 3)
6. Inspect the gun and tank for any leaks.
7. Connect hopper to the gun. (See figure 4)
8. Remove barrel plug and take the gun
off of safety.
9. Cycle the trigger. The gun should operate
with a sharp popping sound.
10.Load paintballs into the hopper and
chronograph the gun, at approximately
280 ft/sec.
Set the ball velocity by adjusting the screw
on the front of the regulator. Clockwise
increases the velocity, and counterclockwise
reduces the velocity. Allow several shots for
the velocity to stabilize after making any
changes. (See figure 5)
Figure 1 Figure 2
Figure 4
Figure 5
Figure 3
5