FIRESTORM Electric Upgrade Kit for the Autococker Assembly Instructions Designed & Manufactured by PGI
Table of Contents Introduction Safety Parts Diagram Parts Diagram Listing Getting Started Autococker Disassembly Installation of Firestorm Kit Adjusting Secondary Regulator Warranty 1 1 2 2 3 3 3 4 5
P A I N T G U N S I N T E R N A T I O N A L , L L C installing or removing the barrel plug. When the marker is not in use always have the safety engaged. Introduction FIRESTORM is a revolutionary design featuring a combination of electronics and pneumatics . The end result is possibly the fastest and most reliable Autococker in the world. It has no sear, no timing, fires at 10-14 balls per second and operates on either CO2 or Nitrogen.
P A I N T G U N S I N T E R N A T I O N A L , L L C Parts Diagram Listing 1 screw set 8 cylinder 2 secondary regulator housing (w/solenoid) 9 ram 3 secondary regulator 10 back block 4 bottom o-ring 11 ΒΌ hose 5 spring 12 bottom regulator 6 hammer 13 grip (covers not shown) 7 top o-rings (2) 14 battery connector 2
P A I N T G U N S I N T E R N A T I O N A L , L L C Getting Started lower hammer bore by screwing into existing threads. 1. Unpack the FIRESTORM kit from the box and inspect for damage. 2. Slip back block onto cylinder with bolt and ram installed. 2. Check inventory of parts received against diagram and list of parts on previous page. 3. Push back block against Autococker body and tighten with #8 set screws with Loctite.
P A I N T G U N S I N T E R N A T I O N A L , L L C 11. Attach one wire to terminal TB1. 12. Attach second wire to adjacent terminal. 13. Install grip with screws supplied. CAUTION: Be carefull not to pinch wires between the body of the gun and the grip frame. Use grease to assure spring and balls are retained in the trigger block. 7. Slide front block over pressure regulator housing. 8. Tighten front block with #8 set screws using Loctite. 14.
P A I N T G U N S I N T E R N A T I O N A L , L L C CAUTION: Balls can be discharged from drop tube until secondary regulator is adjusted correctly. 21. Secondary regulator pressure is correctly set by loading two balls at a time and increasing secondary regulator pressure until second ball drops freely into the breach. 22. When the second ball drops freely in to the breach, set jam nut on secondary regulator screw.
