User Guide

Chapter 14: Reference
247
MIDI Input Driver
Select the Driver that you would like to use for input from a MIDI keyboard. If you don't have a MIDI keyboard,
you can select <No MIDI/Sound Input>.
MIDI Output Driver
Select a Driver For MIDI Output. This also includes Sound Card output (like Sound Blaster).
Perhaps the easiest way to configure Band-in-a-Box is to press the [Run Driver
Wizard..] button.
The MIDI Output Driver Wizard dialog will take you step-by-step through the process of auditioning and
selecting an appropriate driver. This assumes that the appropriate Windows sound drivers are installed and correctly
configured.
Synthesizer / Sound Card
Selecting the type of synth allows Band-in-a-Box to automatically load in the appropriate Drum/Patch kit file
(*.DK). It is not essential to set this - if you don't then leave it as <synth card not listed >.
Driver Latency
Software synths (like the Roland VSC) have a specific timing issue associated with them; “latency.” This means
that it takes about 430ms from the time Band-in-a-Box sends the MIDI information to the Virtual Synthesizer to
generate and hear the sound. To keep everything (i.e. the notation display, etc.) "in sync," you should set this
latency option. In most cases, Band-in-a-Box will prompt you to do this. If you are using a regular sound card or
MIDI module you should not encounter any latency, so you should set the latency option to zero (0) if it's not
already set this way.
Use DXi Synth
Check the Use DXi Synth checkbox to enable DXi playback.
To use this option, you must have a polyphonic DXi synthesizer installed on your computer, such as the
Roland/Edirol VSC DXi. It will also be most convenient if your DXi synthesizer can use General MIDI or GM2
patches.
DXi Synth Settings
To select the DXi synthesizer, click the [DXi Synth Settings] button, which will open the DirectX Plugins window.
Select your DXi synth and apply real time DirectX effects.
GM2 support
The type of GM2 support is set here. The choices are:
- General MIDI 2 support: If you're using the Roland VSC3, or a newer Sound Canvas (i.e. newer than 1999, or
newer than the Roland SC88), then choose this GM2 support.
- Roland GS (older Modules): “Older” Sound Canvases (SC55/SC88) support GS, but not GM2. The good
news is that they have the same patches available, just at different locations. So if you choose this option,
Band-in-a-Box will find the patches at the “GS” locations instead of the “GM2” locations. If you have a newer
GS module like the SC8820, it supports both GM2 and GS - you should likely choose GM2.
- No GM2 support: Most sound cards (Sound Blasters etc.) don't have GM2 support yet, so just support the 128
sounds. Band-in-a-Box will use the closest instrument in these cases.