Installation Guide

ManualsBrandsPfister ManualsFaucet HandlesAvalon 3-Handle Metal Lever Handle Rebuild Kit, Brushed Nickel

1-800-PFAUCET (1-800-732-8238)

For Toll-Free Pfaucet information call

1-800-PFAUCET (1-800-732-8238) or visit www.psterfaucets.com

• Installation Support

• Care and Warranty Information

Español:

Para obtener información mediante llamadas gratis,

llame al 1-800-PFAUCET

(1-800-732-8238) o visite www.psterfaucets.com

• Apoyo a instaladores

• Información sobre cuidado y garantías

Français:

Pour les renseignment concernant le service san

frais de Pfaucet, appelez 1-800-PFAUCET (1-800-

732-8238) appel ou visite www.psterfaucets.com

• Assistance à l’installation

• Informations sur l’entretien et la garantie

■S104-3■

3 Handle Tub & Shower Upgrade3 Handle Tub & Shower Upgrade

La mejora de tina y ducha en 3 manijas La mejora de tina y ducha en 3 manijas

La amélioration de bain et douche dans 3 La amélioration de bain et douche dans 3

poignéespoignées

35003-0300

January 7, 2020

12568-35

SAMPLE COPY

Summary of content (6 pages)

PAGE 1
■S104-3■ L P AM S Y P O C E 3 Handle Tub & Shower Upgrade La mejora de tina y ducha en 3 manijas La amélioration de bain et douche dans 3 poignées 1-800-PFAUCET (1-800-732-8238) For Toll-Free Pfaucet information call 1-800-PFAUCET (1-800-732-8238) or visit www.pfisterfaucets.
PAGE 2
1 BEFORE PROCEEDING WARNING: Read all the instructions completely before proceeding. Pfister recommends calling a professional if you are uncertain about installing this product! This product should be installed in accordance with all local and state plumbing and building codes. WARNING: This product has been designed for use with the Pfister 01 series valve. It will not work with any other product. 2 SHUT OFF WATER SUPPLY Locate water supply inlets and shut off the water supply valves.
PAGE 3
4 4A 4C 4D 4E 4G 4F 4B 4C 4C 4E 4F 5 5D 5D 5B 5A 5C 5A 4 COMPONENT REMOVAL For removal of HOT and COLD Water Valves (4A/4B), be sure Stems (4C) are in the full ON position and water is turned off. Remove old unit such as Trim (4D), Flanges (4E), Nipples (4F) and Valves (4A/4B/4G), as shown. Clean the mounting surface thoroughly.
PAGE 4
6 6A 6C 6E 6F 6D 6G 6A 6B 6J 6L 6K 6F 6F 6L 6M 6G 6H 6J 6K 6M 6M 6 NEW COMPONENT INSTALLATION Insert Rubber Washers (6A), Hot/Cold Valves (6B/6C) and Diverter Valve (6D) into existing Valve Body (6E). Set Stems (6F) in the CLOSED position. Position Flanges (6G) on Valves (6B/6C/6D) with Drain Hole (6H) at the bottom. Screw Retainer Sleeves (6J) onto threaded section of the Stem (6F). Tighten Retainer Sleeves (6J) by hand until Flanges (6G) are snug to finished wall surface.
PAGE 5
7 SHOWER ARM INSTALLATION 7 7B Remove existing Shower Arm and Shower Flange. Insert the long end of Shower Arm (7A) through the Shower Flange (7B). Apply PTFE plumber's tape to both ends of Shower Arm (7A) according to manufacturer's instructions. Screw the end of Shower Arm (7A) into pipe elbow inside the wall. Slide Shower Flange (7B) tight to the wall. 8 UNIT START UP Turn on hot and cold water supplies, and check all connections for leaks.
PAGE 6
For warranty information go to www.pfisterfaucets.com Para la información de la garantía vaya a www.pfisterfaucets.com Pour l’information de garantie allez à www.pfisterfaucets.