Instructions / Assembly

ManualsBrandsPfister ManualsKitchenClairmont Single-Handle Pull-Out Sprayer Kitchen Faucet in Polished Chrome

ENGLISH

Water Supply Lines are not included. Please

consult manufacturer and/or its instructions

for the correct method of installation of supply

lines and ttings.

CAUTION: Incorrect application of supply

lines and ttings may result in the failure or

leak of the supply lines and ttings.

11 WATER SUPPLY CONNECTIONS

A. Thread Inlet Connectors (11A) into Water Supply Lines (11B).

B. Remove Protective Cap (11F). Gently separate hot and cold Faucet Inlets (11C),

approximately 1 in. (26 mm) apart. Connect Water Supply Lines (11B) onto Faucet Inlets

(11C). Hot water supply line goes to hot inlet tting indicated by red tag.

C. Insert Clip (11D) into Inlet Connector Holes (11E) to secure water supply lines, as shown.

12 PULL-OUT HOSE ATTACHMENT

From underneath sink, remove Protective Cap (12E). Push Quick Connector (12A),

located on the end of the Pull-Out Hose (12B) rmly upward onto the Receiving Tube

(12C), until unable to push any further. Pull down on the Quick Connector (12A). If the

housing and the Inner Collect (12D) separate slightly but do not pull off, the Receiving

Tube (12C) quick connect is secure.

13 UNIT START UP

Turn on hot and cold water supplies, and check for leaks above and below the sink

14 FLUSHING

To prevent damage to the internal parts of your faucet from debris that may have collected

in the water lines, it will be necessary to ush the faucet. Lift the faucet handle (14A)

up to the full on position. Run water for one minute. Repeat in hot and cold positions.

Note: For valve functions (see step 17).

HOT COLD

11C

11A

14A

11B

11C

11A

11C

11F

11B

11D

11E

11B

11D

11B

11A

1” Max.

(26 mm)

Red Tag

12C

12A

12C

12D