Installation Guide

ENGLISH
ENGLISH
16
17
18
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.psterfaucets.com
• Installation Support
• Care and Warranty Information
CAUTION: Maintenance
1. Replacement parts may be available at the store where you
purchased your faucet.
2. When replacement parts are not available, please write or call
Pster Consumer Service.
3. Always turn off water and relieve pressure before working on
your faucet.
16 FINISH WALL PREPARATION
Make appropriate holes to nished wall. Pster recommends that all Tub Spout and
Shower Outlet holes be 1
1
/
4
” diameter. For center hole on plaster wall use 4
3
/
4
”
diameter.
CAUTION: Make sure that leak tests and ushing are performed before preparing
the nished wall.
17 THIN WALL INSTALLATION
Knock out Center Section (17A) of Plaster Guard (17B) and remove Screws (17D). For
installation of thin walls, use Support Plate (17C) in addition to Plaster Guard (17B). For
installation to other wall types, do not use Support Plate (17C). Use of Plaster Guard
(17B) is optional. For center hole on a thin wall use 4” diameter.
18 REVERSED INLET LINES
If hot and cold inlets are reversed (back-to-back installation), (18C) unscrew the
plasterguard and bonnet assembly. Rotate the Bonnet Assembly (18A) 180° with Notch
(18B) facing up and reassemble.
NON STANDARD INSTALLATIONS
5
17B
4” Dia
17C
17B
17A
17C
17D
SHWR
TUB
18C
HOT COLD
COLD HOT
180°
18A
18A
18B
1 ¼" Dia.
1 ¼" Dia.
4 ¾4 ⅞ " Dia.
+
-
⅛"
+
-
⅛"