Owner's manual

5
8 VALVE FUNCTION (Fig.D)
By lifting the Lever Handle (1) up, the valve will be activated
allowing water to ow. The water ow will increase by
continuing to lift up the Lever Handle (1). By rotating the
Lever Handle counter-clockwise, the water temperature will
decrease to cold ow only. By rotating the Lever Handle
clockwise, the water temperature will increased to hot ow
only.
9 FLUSHING (Fig.E)
After installation is complete, turn water supply valves on
and turn faucet on. Allow both hot and cold water to run at
least one minute each until all foreign matter has cleared
the line. While water is running, check for leaks.
10 CLEANING THE AERATOR (Fig.F)
It is advisable to periodically clean the aerator, in order
to avoid build-up of dirt and limestone, which in time
could gradually limit the water ow. To clean the Aerator,
disassemble Aerator Housing by separating the Aerator
Head (5), Basket (6) and Washer (7). Once parts have been
cleaned, reassemble by reversing steps.
11 WALL HOOK INSTALLATION (Fig.G)
Drill one
1
/
4
” Dia. Hole (1). If installing into a stud, drill a one
1
/
8
” Dia. hole and do not use the anchor (2). Insert anchor
(2) into hole (1) and tap ush with wall. Place wall mount
(3) onto wall and insert mounting screw (4) through wall
mount hole (1) and tighten until wall mount (3) is ush with
the wall. (Do Not Over Tighten!) Insert front cover (5) into
Wall Mount (3). Shower hose (6) hangs on wall mount hook
(7) as shown.
E
5
6
7
F
1
4
2
3
3
7
7
6
6
5
G
D
D
HOT
COLD
OPEN