Installation Guide

ENGLIS HENGLIS H
ENGLISH
4
3
5
6
Thank you for purchasing this Price Pfi ster product. All Price Pfi ster products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING:
Read all the instructions completely before proceeding. Price Pfi ster
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
WARNING:
This product has been designed for use with the Price Pfi ster 15-IWD
series diverter valve. It will not work with any other product.
Please review the
15-IWD
series diverter valve
installation instructions before installing this product.
2 SHUT OFF WATER SUPPLY
L
o
ca
te water supply inlets and shut off the water supply valves. These are usually fou
nd
near the water meter. If you are replacing an existing unit, remove the old unit and clean
the mounting surface thoroughly.
3 TOOLS RECOMMENDED
• PTFE plumber's tape or thread sealant • Philips head screwdriver
• Pliers •
Adjustable
wrench • Flashlight • Cloth
Your installation will require a pipe nipple for the spout installation as well as other
additional tools.
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are
included.
A
Handle
B
Trim Flange
C
Washer
D
Retainer Sleeve
E
Extension Stem
F
Hex Wrench
G
Set Screw
I
f any of these items are missing, please contact Price Pfi ster Consumer Service
at 1-800-Pfaucet (1-800-732-8238).
5
VALVE LOCATION
Be sure that Diverter Valve Body (
5
A
5A5
) is positioned correctly in wall, where the
Supply Valve Shower Outlet is to connected to one of the Diverter Valve Body
Inlets (
5
B
). Be sure that Shower Outlet (
5
C
) and Tub Outlet (
5
D
) connections
are properly connected. Be sure that the
other Diverter Valve Outlet (
5
E
) is
E) is E
plugged.
Center Hole (
5
F
) on wall is
F) on wall is F
2
.00
”
Dia.
6
COVER REMOVAL
Remove Plastic Cover (
6
A
6A6
) from
Diverter Valve Body
(
6
B
).
2
A
INLET
2.00” Dia.
5A
TO
PRIMARY
OUTLET
TO
SECONDARY
OUTLET
C
B
D
E
F
G
5E
5E
5C
5B
5D
5F
5B
6B
6A