Operation Manual

is
Needle
threader
Lower the
sewing foot by
means
of
lif
ting lever 16.
Turn
the
hand
wheel until right looper
31
is
positioned right
of
the needle
(see
top of page 18).
Place the thread
in slot A
of needle
threader 42
and
tauten
it
a
little, holding the needle
threader
a
little
turned to the front.
With the
needle located
between
the
two guide lugs B
move the needle
threader slowly
downwards
at
the rear
side
of the needle
until small hook
C
engages in
the needle eye.
Hold the
thread taut and place it in
hook D; it will
then automatically
be
placed
in hook
C,
too.
Pull the
needle threader to the rear, out
of
the needle eye,
and the thread will
be
pulled through
the
eye.
Pull the thread
completey through the
needle
eye.
Thread spool change
on threaded machine
Cut
the threads close to
the thread spool. Place new
thread spools on spool
holders 1 7.
Tie
the
threads still in the
machine and the new threads to-gether.
Pull
the needle
threads out
of
the
needles.
Now pull
at
the thread ends until
the knots are about
1
5 cm
past
the last thread
guide before the needles. Cut the knots
off and
pull the threads
through
the
respective
needle
eyes.
The looper threads
can
be
pulled until
past
the
looper eyes
without interruption. Pull about 10 cm of
thread
through the looper eye.
11