Operation Manual

Threading
the needle
Threading of guide
wires 18 and
of the
thread guide behind
the carrying
handle
is shown on
page 7
In
the
left
hand
illustration
the threading
path is shoiiri
from
the
blue tension (1)
up
to the right needle
(6). At point
5
the
thread
must be pulled behind
the thread
retainer
After
threading the
machine, push handle
2
down, and close
work
support 12
and
looper
cover 10
Cut the threads
close to the
thread spool. Place new thread
spools on
spool holders 17.
Tie the threads
still in the machine and
the new
threads
together Pull
the
needle thread
out of the
needle. Now pull at the thread
ends until
the
knots are about
15
cm
past the
last thread
guide before the needles.
Cut the knots off
and pull the threads through
the
respective needle
eyes. The
looper threads
can be pulled until
past
the
looper eyes
without
interruption Pull about
10
cm of thread through the
looper eye
Thread
spool change on threaded
machine