Operation Manual

2:6
B
C
A
C
A
B
D
C C
E
Preparations
Bobbin winding
Winding from horizontal position
1. Place an empty bobbin on the bobbin spindle,
with the logo facing up. Use only the original
3)$))EREELQVDSSURYHGIRUWKLVPRGHO
2. Place the thread spool on the spool pin in
KRUL]RQWDOSRVLWLRQ6OLGHDVSRROFDSWLJKWO\
against the spool.
 3ODFHWKHWKUHDGLQWRWKHWKUHDGJXLGH$IURP
front to back. Pull the thread counter-clockwise
DERYHWKHEREELQZLQGHUWKUHDGJXLGH%DQG
WKHQWKURXJKWKHEREELQWKUHDGJXLGHV&DW
the rear.
Note: Make sure the thread is pulled securely inside
the pre-tension device for correct thread tension.
 7KUHDGWKURXJKWKHKROHLQWKHEREELQ'IURP
the inside to the outside.
 3XVKWKHEREELQOHYHUWRWKHULJKWWRZLQG$
pop-up appears on the screen to inform you
WKDWEREELQZLQGLQJLVDFWLYH3UHVVWKHIRRW
control to start winding the bobbin.
When the bobbin is full, the bobbin winding
will slow down and stop automatically. The
SRSXSFORVHV5HPRYHWKHEREELQDQGFXWWKH
WKUHDGXVLQJWKHEREELQWKUHDGFXWWHU(
Winding through the needle
Make sure that the presser foot and the needle are
LQWKHXSSRVLWLRQ2QO\ZLQGWKURXJKWKHQHHGOHLI
using a metal presser foot.
%ULQJWKHWKUHDGXSIURPWKHQHHGOHXQGHU
the presser foot, upward through the left-hand
threading slot and through the bobbin thread
JXLGHV&7KHQIROORZVWHSDQGDERYH