Operation Manual

Satin
stitch
mitered
corners
Mitered
corners
(with
an angle
of 45°)
can
be
achieved
by
altering
the
width
of the
satin
stitch
zigzag
while
sewing.
•
Select
zigzag
stitch
12
(right
needle
position).
• Set
stitch
width
to
6
mm,
stitch
length
to
0.2-0.3
mm.
•
Set the
needle
thread
tension
to
3.
• Satin
stitch
a
single
straight
line.
• To
miter
the
corner,
lower
the
needle
into
the
fabric
on
the right
side
of
the
stitch,
reduce
the
stitch
width
using
the
-1+ button
A (1)
by
0.5 mm.
Sew one
stitch.
•
Reduce
the
width
again
by
0.5 mm
and sew
one
stitch.
Continue
until
the
stitch
width
is
reduced
to
0.5
mm.
• Turn
the
handwheel
towards
yourself
until the
needle
pierces
the
fabric
in the
right-hand
position.
Turn
the
fabric
90°
and
sew
one
stitch.
•
Increase
the
width
by
0.5 mm
to
1 mm.
Sew
one
stitch.
• Increase
the
width
by 0.5
mm
again
and sew
one
stitch.
Continue
until
the
starting
width
is
reached.
•
Continue
embroidering
a straight
line
at
the
6.0 mm
width.
If the
corner
is
to run
in
the
opposite
direction,
work
with
the
left-hand
needle
position
(stitch
12 and
‘Pattern
mirror
button
(30)).
Decorative
buttonhole
This
buttonhole is
an
attractive
variation
of the
classic
linen
buttonhole.
Since
you
determine
the
seam
width
yourself
the
buttonhole
can
be up
to
12mm
wide.
•
Set stitch
No.
3, stitch
width
3
mm,
stitch
length
0.2
mm.
•
Set
needle
thread
tension
at
3.
•
Sew
two
seams
1
mm
apart
the
length
of
desired
buttonhole.
• Select
stitch
No.
12 and
stitch
over
the two
ends
with
a
triangle.
•
Using
-1+
button
A
(1).
alter
the
stitch
width
gradually
from
0
mm
to
3 mm
and
back
to
0
mm
during
sewing.
The
tip
of
the
triangle
should
meet
in the
middle
of
the
two
seams.
90