Operation Manual

3:10

PFAFF® creative™ Color Touch Screen

Stitch width safety

Select this function when using a straight stitch

presser foot to lock the needle in center position for

all stitches, preventing damage to the needle and/or

presser foot.

This function is automatically selected, and cannot

be deselected, when the straight stitch needle plate

is attached.

When turning on the machine with this setting

activated and for every stitch selection that is not

a straight stitch, a pop-up informs you that it is set

to straight stitch. Deselect stitch width safety to go

back to normal sewing.

Note: Twin needle and stitch width safety cannot be used

at the same time.

Start/stop button safety

Select this function to disable the start/stop button

in sewing mode. This prevents the machine from

starting to sew if the start/stop button is touched by

mistake. When this function is selected, you must

use the foot control to sew.

Cut jump stitches

Your machine features the automatic function

Cut jump stitches. This function saves you time

trimming after the embroidery is completed. When

Cut jump stitches is selected your machine will trim

the top jump stitch thread and pull the thread end

to the underside of the fabric as you embroider.

Note: Your machine will also cut the thread after you

have changed to a new color. Hold the thread end when

you start embroidering again, so that you can easily

remove the thread end when cut.

Designs marked with this symbol are

programmed for Cut jump stitches. Jump stitch

trim commands can be added to any design using

the 5D™ Organizer Software, included with your

machine.

Automatic thread snips

When selected, the automatic thread snips is

activated. The threads are cut automatically and

the presser foot raises at color changes or when

an embroidery is À nished. When deselected, no

automatic thread snips will be performed.