Operation Manual

15a 15b 15c

14a 14b

10 11 12

5:2

Sequencing

In sequencing, you are creating and adjusting a sequence of stitches. Combine various 9mm stitches

and stitch fonts from the machine or from an external device. Stitches made in Stitch Creator can also be

inserted in a sequence.

You can create sequences up to approximately 500mm (20”) long. You can see how long your actual

sequence is in the upper left corner (1).

Sequencing - overview

1. Approximate length of sequence

2. Stitch selection area

3. Scroll bar (scroll through stitch

categories)

4. Stitch À eld

5. Delete

6. Duplicate

7. Mirroring side to side

8. Mirroring end to end

9. Arrows

10. Stitch width

11. Stitch length

12. Stitch density

13. Width/position toggle

14. Save options

a) Save to personal menu

b) Save to personal À les

15. Sequence commands

a) tie-off

b) stop

c) cut

16. Horizontal preview

17. Stitch positioning

Note: All symbols and options will not be

shown at the same time.

Sequencing can be used in both sewing mode and in embroidery mode. To open, just touch the

sequencing symbol (A) on the task bar. To close sequencing and sew your created combination, touch the

symbol on the task bar again.

Note: If sewing mode is active and your programmed stitch is ready to be sewn, you can also close the active function

by pressing the foot control, or by pressing the start/stop button.

Not all stitches, e.g. buttonholes, are available to use in a sequence. If you try to select an unavailable

stitch, a pop-up will notify you.