Operation Manual

3:10
A
B
C
Reverse/start-stop button
In the embroidery mode the reverse sewing button (14) becomes a
start-stop button.. Use the button when you want to start your embroi-
dery and when you want to stop. Keep the button depressed in order to
start the embroidery.
Note: You can also use the foot control to start embroidering.
Design width
The width of a design will be shown in the window in mm (A). You
can change the design width by pressing the + and - buttons (51). The
design can be scaled between 75% to 125% or to the limit of the hoop
size.
Thread tension
When loading a design the thread tension will be set to a predefi ned
value (C). If you want to change the thread tension use the + and - but-
tons (53) to increase or decrease the tension.
Design length
The length of a design will be shown in the window in mm (B). You
can change the design length by pressing the + and - buttons (52). The
design can be scaled between 75% to 125% or to the limit of the hoop
size.