Operation Manual

B
A
1
2
3
4
R
N
N
R
N
R
Preparations 11
Upper looper
Disengaging
For coverstitch and chaintitch sewing the upper looper
needs to be disengaged.
• Turn the handwheel until the upper looper is in its
lowest position.
• Push the clutch lever to the right and back until
position B is visible from the front.
Engaging
• Turn the handwheel until the upper looper is in its
lowest position.
• Pull the clutch lever toward you until position A is
visible from the front.
Changing to coverstitch table B
For coverstitch and chainstitch sewing the coverstitch
table B should be used.
• Lift the hook (1) to release the cutter cover A and pull it
towards you.
• Insert the coverstitch table B by À tting the two front
pins (2) into the holes (3) and make sure the hook (4)
clicks into place.
Stitch À nger lever setting
The stitch À nger lever should be set to N for all standard
overlock sewing. To sew rolled edge you need to retract
the stitch À nger by setting the stitch À nger lever to R.
When moving the stitch À nger lever, be sure to push the
lever as far as it will go in each direction.