Operation Manual

3:5
3:5
Decorative sewing and embroidery techniques
Uneven embroidering
• Place stabilizer under the fabric.
• Set needle thread tension to
“buttonhole”, select zigzag stitch G
(1546), E (1536/1526), set stitch length to
“buttonhole” and select the center needle
position
.
• Increase or decrease the width of the
stitch using the width dial (27).
Note: If you selected the right or left needle
position, the stitch width will only change in
one direction.
Embroidering with a dense zigzag
stitch/Tapering
Tapering is easy with your select sewing
machine. By adjusting the width of
this dense zigzag stitch you can create
interesting embroidery.
Even embroidering
• Place stabilizer under the fabric.
• Set needle thread tension to
“buttonhole”, select zigzag stitch G
(1546), E (1536/1526), set stitch length to
“buttonhole” and select the center needle
position.
• Turn the width dial (27) smoothly
and consistently from 0 to 5
mm and
back again to 0 while sewing at a constant
speed through the procedure.
Note: If you selected the right or left needle
position, the stitch width will only change in
one direction.