Operation Manual

2:5
B
A
Utility stitches and practical sewing
Remember!
When blindhem stitching, if you select a
needle position other than right, and
stitch width other than 5, make sure the
needle does not strike the bar of presser
foot 3.
If the stitches are visible on the right side,
adjust edge guide B by turning adjusting
screw A.
Use the needle position
and the
width dial (27) to regulate the penetration
of the needle in the crease.
Stitch H (1546)
Stitch D (1546), stitch H (1536/1526)
Blindhem stitch (Model 1546)
Blindhem stitch H is best suited for
invisible hems; sewing by hand is no
longer necessary.
• Serge the edge of the hem
• Fold the edge inwards by the hem
width.
• Now unfold the hem again so that the
hem edge protrudes by about 1 cm
• Place the fabric under the sewing foot
so that the crease line runs along edge
guide B.
• Using the needle positioning knob
28, select the needle position to the right
.
• When the needle enters the crease
line, it must only pick up one À ber of the
fabric.
Blindhem stitch (elastic)
Stitch D (1546) or H (1536/1526) is a blind
stitch for woven or elastic fabrics. The
hem is sewn and overcast at the same
time.
stitch
H/D
- /H
- /H
5-
5-
5-
1-2
1-2
1-2
3-5
3-5
3-5
0/3
0/3
0/3