Operation Manual

Installation and commissioning
8 - 3
8.01.04 Fitting the lower belt guard
Fig. 8 - 04
● Position belt guard 1 so that motor pulley
and v-belt can run freely.
Fig. 8-04 shows a Quick
motor. If a different motor is
used, please refer to the
instruction manual of the motor
manufacturer.
1
Fig. 8 - 05
8.01.05 Fitting the synchroniser
● Push synchroniser 1 onto the shaft.
● Tighten screws 2 a little.
● Connect the synchroniser plug at the
control box.
● Adjust the synchroniser (see Chapter
11.05.14, Adjusting the synchroniser).
2
1