Operation Manual

8 - 2
Installation and commissioning
8.01.03 Fitting the upper belt guard
If a large balance wheel is in
use, break off corner 1 of belt
guard part 3.
● Screw stop piece 2 onto belt guard part 3.
● Screw on belt guard part 3 with screws 4.
● Screw on belt guard part 5 with screws 6.
● Secure belt guard part 7 to the table top
using woodscrews 8.
● Loosen nuts 1.
● Tension v-belt by adjusting bracket 2.
● Tighten nuts 1.
Fig. 8-02 shows a Quick motor.
If a different motor is used,
please refer to the instruction
manual of the motor
manufacturer.
8.01.02 Tensioning the v-belt
Fig. 8 - 02
Fig. 8 - 03
2 cm
1
2
5
3
2
6
6
4
4
8
8
8
7