Data Sheet

User Manual

WiLoader Revision G
The original password of this network is set to eight consecutive zero digits(00000000), which
can also be changed later. After connecting the computer to WiLoader’s network, the user
should run WiLoaderFX software. The software can be found in the bin directory or in case of
macOS operating system the application is in the main folder. WiLoader name will be displayed
in the software list by clicking the scan button inside WiLoaderFX. Then, by clicking scan
button inside the Setting tab, it searches for existing networks and after a few seconds their
names are displayed in the drop down list of WiFi networks. After selecting the desired network
and entering the password, press connect button and shortly after WiLoader will connect to
user’s selected network.!
If the network created by WiLoader and the user selected network both use the same WiFi
channel, the network connection status will be displayed at the top right side of the software
(opposite the Net label) during connection. Otherwise, due to the need for WiLoader WiFi
channel to be identical in the AP and Station mode, WiLoader Network channel changes to the
selected network channel and the user's computer will probably be disconnected from the
network.!
4