Data Sheet

User Manual

WiLoader Revision G
1) WiCOM port is selected and upload command is chosen.(boot-loader will be used)!
2) WiLoader is selected as the programmer and upload using programmer or burn boot-loader
is chosen.(Target MCU will be programmed via SPI pins)!
Only for the first time, when WiLoaderFX software is not running, Arduino opens the
WiLoaderFX software by calling the WiLoaderInterface. Then, the user should press the scan
button and choose a WiLoader inside the WiLoaderFX software. Afterwards, the user can
perform the needed operation again. From now on, the user can minimize the WiLoaderFX
software and continue to program using only Arduino IDE interface.!
To use the WiFi-UART feature, the user can also work with the Arduino Serial Monitor software
in addition to the Terminal tab inside the WiLoaderFX software.!
Note: When Arduino Serial Monitor is used and the WiLoaderFX is closed, the software will
automatically open.!
Note: Simultaneous use of Arduino Serial Monitor and the Terminal tab inside WiLoaderFX is
possible.!
Note: If UART baud-rate is changed by Arduino Serial Monitor, this new value will be stored
and applied to WiLoader. (There is no need for resetting WiLoader)!
32