Data Sheet

User Manual

WiLoader Revision G
When the user selects the options “add CR” or “Add LF,” 0x0D or 0x0A byte will be added at
the end of data string that are consecutively the characters for Carriage return and Line feed.!
The user must use the Enter key, in order to send the written data. The clear button is used for
clearing the terminal screen and the reset button is for resetting the MCU, which is usually
used to carry out tests in projects along with sending and receiving serial data.!
It’s important to note that up to 5 simultaneous terminals can also be connected to WiLoader.
For example, if the user works with Arduino Serial Monitor and Smartphone application
Terminal, there is no problem in connecting multiple users to WiLoader’s serial port. In this
case, the received bytes from the MCU’s UART port, will be sent to the last client connected to
WiLoader or the last one that sent any data to WiLoader.!
Each time the target board and as a consequence, WiLoader will be turned off and on, all the
established connections will be lost, so the user should initiate and establish all the
connections again.!
20