Manualshelf

Data Sheet

ManualsBrandsPetunia Tech ManualsArduino Compatible PartsWiLoader Wireless AVR & Arduino Programmer
11121314151617181920
User Manual
WiLoader Revision G
In this case, the application sends the discovery packets to the multicast address, broadcast
address and also the specified address (192.168.1.255) through the Interface or the network
card with the IP address that is entered in “Bind to IP Address” field .!
The volume of the software alert sound can be adjusted in the sound setting section. Sounds
that are played when the user is working with GUI are controlled by the GUI Vol and the ones
played when using the command line interface (for example, working with Arduino software
and other IDEs such as Ateml Studio) are adjustable by Cmd Vol.!
Note: After entering the desired settings, in order to apply and save them inside wiloader.conf
file, the user must click the “Apply to Software” button. If the format of the entered IPs is
incorrect and so an error message is displayed, the settings will not be applied and saved.!
Note: If the bind to ip error is displayed, the software will continue to work only in Broadcast
mode until the correct settings are applied by the user.!
16