Data Sheet

User Manual

WiLoader Revision G
On some routers, the local broadcast address may be blocked, so the multicast option can be
used to find WiLoader using WiLoaderFX. In multicast mode, importing an IP to bind is also
necessary. This IP is in fact the IP of user’s computer received from the network, and if the user
enter this address incorrectly an error massage will be displayed automatically. It’s important to
note that the IP address of user’s computer may change after disconnecting and reconnecting
to the network, as result this address must be updated by the user each time.!
For example, if user’s computer has received the 192.168.1.3 address from the network, In
order to use Multicast, the user must apply the settings as shown in the image below.!
Only using the Bind to IP Address option is also possible. In case, where users have several
active network cards on their computer and want to send packets only through one of these
cards, they can enter the IP address of the desired network card in this field.!
13