Data Sheet

User Manual

WiLoader Revision G
After entering or changing WiLoader’s setting, in order to save them properly the ‘save setting
to WiLoader ’ button must be pressed and after receiving the successful operation message,
for applying these new setting to WiLoader, reset the device using ‘Reset WiLoader’ button in
the software or by pressing the R button on WiLoader itself. !
Note: In order to change only a particular parameter from the ones described before (for
example, only the UART baud rate), the user can leave rest of the fields available blank. In this
case, only the filled parameters will be updated.!
Note: It is possible to change WiLoader’s settings either in station or AP mode. When
WiLoader is in AP mode, as stated before for applying the settings, WiLoader should be reset
and as a result its AP network will be gone, so in order to re-create its network, the S button on
WiLoader should be pressed for 1 second.!
Note: If the static IP option is used, the speed of the connection to the network will be much
higher than the DHCP mode.!
11