Data Sheet

User Manual

WiLoader Revision G
Initially, the UART port is active and its speed is set to 115,200, to change this speed, the
number can be entered to a maximum value of 4,608,000. The user can enter 0 or the word
‘disable’ for disabling the UART port.!
Note: If the UART port is deactivated, the Rx and Tx pins on WiLoader will go to TriState or Hi-
Z, when programming operation is not running.!
By default, WiLoader’s IP is set to DHCP mode and it receives the IP address from DHCP
server of the selected network. However, if the user wants to have a static IP address, the
address should be entered in the appropriate IPv4 format. In this case, it is also necessary to
fill the subnet mask and gateway fields.!
If the user has already set WiLoader’s IP address as static and wants to change it back to
DHCP mode, the word ‘DHCP’ should be entered in Static IP field. In this case, no subnet
mask or gateway are required.!
10