Manualshelf

Data Sheet

ManualsBrandsPetunia Tech ManualsArduino Compatible PartsWiLoader Wireless AVR & Arduino Programmer
11121314151617181920
User Manual
WiLoader Revision G
WiLoader Settings
The setting tab of WiLoaderFX should be used, in order to change the name, AP mode
password, UART baud-rate or IP settings of WiLoader.!
For receiving the latest setting applied to WiLoader, the ‘load setting’ button should be utilized. !
In ‘WiLoader Name’ field, the user can enter any arbitrary name (ASCII or unicode) up to a
maximum of 32 bytes (32 ASCII characters or fewer if using Unicode characters).!
Note: Given that the name of AP network and WiLoader are the same, if non-ASCII characters
are used in its name, the network name in AP mode may not be displayed properly on some
operating systems.!
The AP password should not be longer than 64 bytes, also non-ASCII characters can be
included in the password.!
9