Data Sheet

User Manual

WiLoader Revision G
The number opposite the RSSI shows the strength of the received signal by the WiLoader in
the station mode. If this value is small, it indicates the weakness of the network coverage in the
place where WiLoader is located. The image and color of logo will also vary according to the
value of the RSSI.!
The number in front of the MAC shows the MAC address in the station mode. Although the
MAC address of the WiLoader is different in the AP and station mode, this number will always
display WiLoader MAC address in station mode. This is useful for the situations where users
want to activate MAC filter on their modem/router and needs to add WiLoader MAC address to
the modem’s/router’s white list.!
The text opposite the Net lab indicates the network connection status. Also, when connected
to the network, it will display the network name in green.!
The number in front of IP represents WiLoader’s IP address. If the text in parentheses next to
this number is AP, it states that the WiLoader is in AP mode and WiLoader station radio is not
connected to any network . If the text is ST, it means that the device is in station mode, and if it
is equal to STAP, it indicates that WiLoader is simultaneously in the AP mode and also
connected to another network as a station, in which case the IP Displayed is WiLoader’s
station IP. !
Note: In order to update WiLoader network information, either the scan button must be
pressed each time user needs to renew the displayed information or the auto scan option must
be activated.!
Note: It is possible that few of available WiLoader in network will not appear in the drop down
list each time a scan operation is performed. This happens on account of UDP packets loss in
the network, which will be fixed by running the scan operation again.!
Note: If, for example, ‘WiNew_A’ is selected in the list and there are more than one WiLoader
available on network, the scan operation does not change the selected WiLoader unless user
changes the selected one. Consequently, if a scan operation is performed and the default
(previously selected) WiLoader data is not received, the default WiLoader will not be changed
and the default selection will be displayed as blank, but the user can click on the drop down
list at any given time and choose another as needed.!
8