Instruction Manual

www.petsafe.net 33
In YardMax
™
mode, the
Receiver Collar
corrects when the
pet returns to the
Pet Area.
• Check the YardMax Fence Mode (A/B) Switch is set to A.
• Reverse the wires connected to the Fence Transmitter.
Leave surge protector alone.
• Re-test the boundary.
The Receiver
Collar has to be
held on top of the
Boundary Wire to
activate.
• Charge the Receiver Collar.
• (Traditional Mode only) Adjust Boundary Width Dial
clockwise to increase the distance from the Boundary
Wire that the Receiver Collar activates. Recommended
distance is 10 ft. from Boundary Wire.
• If using a Double Loop, make sure Boundary Wires are
separated by at least 5 feet.
• If the Receiver Collar still has to be held on top of the
Boundary Wire,
refer to YardMax Rechargeable In-Ground
Fence Operating Guide.
The Receiver
Collar activates
inside the house.
• Make sure the Boundary Wire is not running within 15
feet of the house. The signal can transmit through the
walls of your house.
• Make sure Boundary Wires are twisted from Boundary to
the Fence Transmitter.
• (Traditional Mode only) Turn the Boundary Width Dial to
decrease the distance from the Boundary Wire that the
Receiver Collar activates.