Instruction Manual

10 www.petsafe.net www.petsafe.net 11
DE
FR
ES
NL
IT
EN
The Transmitter has two LEDs used to indicate the selected dog. The
Dog 1 Red LED is on the left when holding the unit with the LEDs
facing the operator and the Dog 2 Green LED is on the right.
The Transmitter is factory set in the Dog 1 mode. To verify, press and
release the Dog Select Button multiple times. (The Red LED will ash
once for each press and release.)
Transmitter Indicators
Condition Red LED
Normal Operation OFF
Low Battery - press and release
the Top Button (light blue)
3 ashes every 5 seconds
Dog 1 - The Top Button (light
blue) is pressed
ON length of Top Button (light
blue) press.
Program Mode for adding Dog
2 - Dog Select button held for
5 seconds
Blinks once at the start of the
5 seconds and once when it is
complete
Program Mode for removing
2nd dog - Dog Select button
held for 5 seconds
Blinks once at the start of the
5 seconds and once when it is
complete
Charging ON
Condition Green LED
Normal Operation OFF
Dog 2 - The Top Button
(light blue) is pressed
ON length of Top Button
(light blue) press.
Charging Complete ON